Email this article Experience of application of technological processes for ensuring the constructive reliability of units
- Authors: Kondrashov Y.1, Ermilova E.2, Vidyaskina A.2, Arkhipov R.P.2
-
Affiliations:
- Samara National Research University
- Samara University
- Issue: Vol 5, No 2 (2019): 21.06.2019
- Pages: 37-42
- Section: Articles
- Published: 21.06.2019
- URL: https://dynvibro.ru/dynvibro/article/view/7401
- DOI: https://doi.org/10.18287/2409-4579-2019-5-2-37-42
- ID: 7401
Cite item
Full Text
Abstract
The article proposes measures to improve the reliability and durability of the units under non-standard operating conditions, consisting in the simultaneous introduction of various technological processes and design solutions.
About the authors
Yuriy Kondrashov
Samara National Research University
Email: kon-urij@yandex.ru
Candidate of Technical Sciences, Department of Automatic Systems of Power Plants
Russian FederationElena Ermilova
Samara University
Email: ermilova6488@gmail.com
postgraduate student, Department of Automatic Systems of Power Plants
Russian FederationAnna Vidyaskina
Samara University
Email: vidiaskina@gmail.ru
student, Department of Automatic Systems of Power Plants
Russian FederationR. P. Arkhipov
Samara University
Author for correspondence.
Email: ermilova6488@gmail.com
Russian Federation
References
- Kondrashov, YU. I. (2011), “Konstruktsiya i proektirovanie agregatov i sistem” : electronic learning guide, Minobrnauki Rossii, Samara State Aerospace University n.a. S. P. Korolev (national research university), Electronic text and graphic data. (39,8 Mbajt), Samara,. – 1 el. opt. disk (CD-ROM).
- Demkin, N.B. and Ryzhov, E.V. (1981), Kachestvo poverhnosti i kachestvo detalej mashin , Mashinostroenie, Moscow, Russia, 244 p.
- Braun E. D., Bushe N. A., Buyanovskij I. A. et. al. (1995), Osnovy tribologii (trenie, iznos, smazka) , in CHichinadze, A.V. (ed.), Nauka i tekhnika, Moscow, Russia, 777 p.
- Evstigneev, A.N., ZHukovskiy, A.E., Ivasov, V.M., Kondrashov, YU.I. et al. (1993), Osnovy sozdaniya agregatov avtomatiki pnevmogidravlicheskih sistem letatel'nyh apparatov i dvigatelej . Part 1. Obespechenie konstruktorskoj nadezhnosti i tekhnologichnosti agregatov , NPO “Impul's”, Samara, Russia, 375 p.
- Odincov, L.G. (1981), Finishnaya obrabotka detalej almaznym vyglazhivaniem i Vibrovyglazhivaniem , Mashinostroenie, Moscow, Russia, 160 p.
Supplementary files
